Table 4-1 Termination Procedure For All Applications Except Ce; Figure 4-1 Standard Termination Details (For All Applications Except Ce) - Honeywell 5000TC Series Operation And Maintenance Manual

Series 5000TC Toroidal (electrodeless) Conductivity Sensors
Standard Termination Procedure (for all applications except CE)
CAUTION
Use this standard termination procedure to terminate the sensor or interconnect cable unless the
measuring instrument has the European community "CE" label. In this case, the CE termination procedure
must be used.

Table 4-1 Termination Procedure for All Applications Except CE

Step
1 Strip back the outer cable jacket, outer foil wrap, cellophane wrap, inner foil wrap, and unused black
wire to a distance of 3 inches (76 mm) as shown in Figure 4-1. This exposes the signal shield wire,
the cable shield wire, and the five colored wires (red, green, yellow, white, and blue).
2 Twist the signal shield wire and cable shield wire together, and insulate the new combined shield
wire with shrink wrap or tape.
3 Strip the insulation back from each of the colored wires to a distance of 1/8 inch (3 mm). Then tin each
stripped wire.
4 Using shrink wrap or tape, equally cover the outer cable jacket, and the five colored wires/combined shield
wire. This secures and completes the terminated assembly.
6,*1$/ 6+,(/' :,5(
&$%/( 6+,(/' :,5(
287(5 &$%/(
-$&.(7

Figure 4-1 Standard Termination Details (for All Applications Except CE)

20 Series 5000TC Toroidal (electrodeless) Conductivity Sensors - Operation and Maintenance
Action
&20%,1(' 6+,(/'
6+5,1. :5$33(' 25 7$3('
,11(5 )2,/ :5$3
&(//23+$1( :5$3
287(5 )2,/ :5$3
 ,1&+(6
 PP
6+5,1. :5$3 25 7$3(
 ,1&+
 PP
4/00