Original Accessories/Attachments; Before Use; Charging The Battery Pack; Inserting/Removing The Battery Pack - Parkside PWBSA 12 A1 Translation Of The Original Instructions

CAUTION!
► This charger can only charge the following
rechargeable batteries: PAPK 12 A1/
PAPK 12 A2/PAPK 12 A3/PAPK 12 B1/
PAPK 12 B3/PAPK 12 C1/PAPK 12 D1.
► A current list of battery compatibility can
be found at www.Lidl.de/Akku.

Original accessories/attachments

■ Use only the additional equipment and acces-
sories specified in the operating instructions.
Using attachments or accessory tools other than
those recommended in the operating instruc-
tions can lead to a risk of injury.
WARNING!
■ Do not use any accessories which are not
recommended by PARKSIDE. This can lead to
an electric shock and fire.

Before use

Charging the battery pack

CAUTION!
► Always disconnect the mains plug before
removing or inserting the battery pack 2
from the high-speed charger 0.
NOTE
► Never charge the battery pack at an ambient
temperature of below 10°C or above 40°C.
If a lithium-ion battery is going to be stored
for an extended period, the charge level
should be checked regularly. The optimum
charge level is between 50% and 80%. The
storage climate should be cool and dry and
the ambient temperature should be between
0°C and 50°C.
♦ Insert the battery pack 2 into the high-speed
charger 0.
♦ Insert the power plug into the socket. The
control LED w lights up red.
PWBSA 12 A1
The green LED q indicates that the charging
♦
process is complete and the battery pack is
ready for use.
Push the battery pack 2 back into the appli-
♦
ance.
♦ You should always switch the high-speed
charger 0 off for at least 15 minutes between
successive charging processes. Also disconnect
the power plug from the mains power socket.

Inserting/removing the battery pack

Inserting the battery pack
♦ Snap the battery pack 2 into the handle 1.
Removing the battery pack
♦ Press the two release buttons 3 and remove
the battery pack 2.

Checking the battery charge level

Press the ON/OFF switch 5 to check the
♦
charge level of the battery. The status/
remaining charge will be shown on the battery
charge level display 4 as follows:
RED/ORANGE/GREEN = maximum charge/
performance
RED/ORANGE = medium charge/performance
RED = low charge – charge the battery

Use

Changing tools

Your tool has a fully automatic spindle lock
When the motor is stopped, the power train locks
so that the quick-release chuck 7 can be opened
by turning it . After you have attached the
desired tool and tightened it by turning the chuck
, you can continue working.
The spindle lock is released automatically when
the motor is started (by pressing the ON/OFF
switch 5).
.
GB │ IE │ 7 ■