ADTRAN NetVanta 2054 Quick Start Manual page 6

5) If your connection will use PPPoE (Example: ASDSL), skip to step 8.
a. Type 'ip address dhcp' to set the interface to receive a dynamically
assigned address from your provider.
b. Type 'ip address 5.5.5.5 255.255.255.252' to set a statically assigned
address, given to you by your provider. You should use your own public
IP Address and Subnet Mask.
6) Type 'access-policy Public' to assign the Public policy-class to the Public Interface.
7) If your connection will not use PPPoE (Example: Fiber, Cable Modem or Metro
Ethernet), skip to the section titled 'Configuring the Private Interface'.
8) Type 'interface ppp 1' to create the PPP interface.
9) Type 'no shutdown' to enable the PPP interface.
10) Type 'cross-connect 1 eth 0/1 ppp 1' to associate this PPP interface with the
Public Ethernet Interface.
11) Type 'access-policy Public' to assign the Public policy-class to the Public Interface.
12) Identify the correct Address Setting, and use the appropriate step below.
a. Type 'ip address negotiated' to set the interface to receive a dynamically
assigned address from your provider.
b. Type 'ip address 5.5.5.5 255.255.255.252' to set a statically assigned
address, given to you by your provider. You should use your own public
IP Address and Subnet Mask.
Configuring the Private Interface:
13) Type 'interface vlan 1' to access the Private Interface.
14) Type 'no shutdown' to enable the Private Interface.
15) Note: Perform this step only if you want to change the IP Address of the private
interface. Type 'ip address 10.10.10.1 0.0.0.0' to assign the Private Interface an IP
Address.
16) Type 'access-policy Private' to assign the Private Policy-Class to the Private
Interface.
17) Type 'exit' to leave the Private Interface configuration and return to global
configuration mode.