Mitsubishi SRK20ZFX-S User Manual page 7

Unit indication section
HI POWER light (green)
Illuminates during HIGH POWER operation.
ECONO light (orange)
Illuminates during ECONOMY operation.
How to open the air inlet panel
Place fingers at the recesses on both sides of the panel and pull up the panel
to this side so that it will be opened by about 60 degrees.
How to close the air inlet panel
Push both sides evenly and press further lightly at the center.
Removal, installation of air inlet panel
When removing the air inlet panel for internal cleaning or others, open the
panel by 65 degrees and then pull it to this side.
Removal, installation of air inlet top panel
Removal
Remove the air inlet panel. 1 Grasp the handle of the air inlet top panel and lift up
until you hear a click and the tabs come out. 2 Pull the panel towards you.
Unit ON/OFF button
In emergencies, this button can be used for turning on/off the unit when re-
mote control is not available.
Secure either the upper or lower edge of the air inlet panel by lightly pushing
it in, and then close the panel.
Installation
Align the air inlet top panel with the rail and slide the panel in towards
the back unitl it strikes the end. Push the panel in until you hear a click
and the tabs lock into place and the tabs lock into place.
(To install the air inlet top panel, follow the opposite of the removal
procedure.)
– 6 –
RUN (HOT KEEP) light (green)
• Illuminates during operation.
• Blinks at air flow stop due to the 'HOT KEEP'
and 'CLEAN operation'.
1.5 sec.
ON
HOT KEEP
OFF
0.5 sec.
3 sec.
ON
CLEAN operation
OFF
1 sec.
Page 20
TIMER light (yellow)
Illuminates during TIMER operation.
Page 15
Unit ON/OFF button