Table of Contents
Advertisement
HCD-HX3/HX5/HX7
CD SERVICE MODE
This mode can run the CD sled motor freely. Use this mode, for
instance, when cleaning the optical pick-up.
Procedure:
1. Press the
button to turn the power on.
I/1
2. Press the [FUNCTION] button to select "CD" (HX3/HX7).
Press the [CD] button on the remote commander to select "CD"
(HX5).
3. Press three buttons of [SEARCH],
the message "SERVICE MODE" is displayed on the
fluorescent indicator tube.
4. Press the
– button to move the optical pick-up to inside
track and the message "SLED IN" is displayed on the
fluorescent indicator tube, or press the
track and the message "SLED OUT" is displayed on the
fluorescent indicator tube.
5. Press the [DSGX] button, "LD ON" or "LD OFF" is displayed
on the fluorescent indicator tube. Each time [DSGX] button is
pressed, laser diode on/off is changed over.
6. To release this mode, press the
BT TEST MODE
(HX5/HX7)
This mode is used to check the firmware version and address of
bluetooth module.
Procedure:
1. Press the
button to turn the power on.
I/1
2. Press the [FUNCTION] button to select "BLUETOOTH"
(HX7).
Press the [FUNCTION] button on the remote commander to
select "BLUETOOTH" (HX5).
3. Press three buttons of [SEARCH],
simultaneously, the message "BT Test" is displayed on the
fluorescent indicator tube. Then, the display is automatically
changed to the firmware version of bluetooth module.
4. Press the [DISPLAY] button, address of bluetooth module is
displayed on the fluorescent indicator tube.
5. To release this mode, press the
16
+ and
simultaneously,
Z
+ button to outside
button.
I/1
– and [BLUTOOTH OPR]
button.
I/1
Advertisement
Chapters
Table of Contents
