Table of Contents
Advertisement
NEW ROYAL
MAINTENANCE
This function lets you set all the functions so that machine maintenance is managed better
MAINTENANCE
UNIT CLEANING
DESCALING
CAPPUCCINO MAKER
CLEANING
FACTORY SETTINGS
This function allows the factory values to be reset.
FACTORY SETTINGS
Restoring the factory parameters deletes all the personal parameters set beforehand.
3.2.
Machine indications
CHIUDERE LO
SPORTELLO
LATERALE
INSERIRE VASCA
RACCOGLIGOCCE
INSERIRE
CONTENITORE FONDI
INSERIRE
COPERCHIO CHICCI
RIEMPIRE
SERBATOIO ACQUA
INSERIRE GRUPPO
INSERIRE IL
CAPPUCCINATORE
INSERIRE LA VALVOLA
NEL CAPPUCCINATORE
Saeco International Group
This function is used to run the washing cycle for the Brewing Unit
This function is used to run the descaling cycle
This function lets you run the washing cycle for the cappuccino maker used for making beverages
containing milk
For the machine to become
operative, the service hatch
must be closed
Insert the drip tray
Insert the dreg drawer
Close or correctly position the
coffee bean hopper lid to en-
able dispensing of any bever-
age
Take out the tank and fill it
with fresh drinking water
Insert the brewing unit in its
correct location
An operation has been select-
ed that requires the dispens-
ing of milk.
Insert the cappuccino maker
in the machine as specified in
the manual.
An operation has been selected
that requires the dispensing
of milk. Insert the valve in the
cappuccino maker.
AGGIUNGERE CAFFE'
SVUOTARE
CONTENITORE FONDI
RIAVVIARE
PER RISOLVERE
IL PROBLEMA
Rev. 00 / July 2011
03 USER INSTRUCTIONS
Fill the coffee hopper with coffee
beans.
The appliance requires a descaling
cycle.
If this message appears you may
continue to use the machine but the
operations may be compromised. Re-
member that any damage caused due
to lack of de-scaling is not covered by
the warranty.
The machine requires replacement of
the "Intenza" water filter with a new
one. Proceed with the replacement of
the filter. The alarm is displayed only if
the "Enable Filter" function is ON.
The machine indicates that in a few
cycles' time the dreg drawer will need
emptying.
This message allows you to carry on
dispensing beverages.
Remove the dreg drawer and empty
out the dregs. Note: the dreg drawer
must only be emptied with the ma-
chine switched on. If the drawer is
emptied with the machine switched
off the machine cannot register the
emptying operation.
An event has occurred that requires
restarting the appliance. Note the code
(E xx) shown at the bottom. Switch
off the machine and switch it back on
after 30 seconds. If the problem per-
sists, contact the assistance center.
Page
/ 04
03
Advertisement
Table of Contents
