Table of Contents
Advertisement
5. Standing on the right side of the sand saw
(Figure 2), pull the motor towards you.
6. Place the belt (C, Fig. 5) around the wheel
pulley (B, Fig. 5) and motor pulley (A, Fig. 5).
7. Standing on the right side of the sand saw,
push the motor away to put tension on the belt.
8. With a 6mm hex wrench, tighten both socket
head cap screws (D, Fig. 5).
Mounting the Switch
The switch is mounted to the saw body casting on
the front side of the saw between the upper and
lower doors.
Referring to Figure 6:
1. With a cross-point screwdriver, fasten the
switch (A) to the casting (C) with the two
screws already on the switch box (B). These
screws also hold the back plate of the switch
box in place.
Note: There are two mounting holes at the upper
screw location. Use the left mounting hole.
2. In the remaining top mounting hole, secure with
an M5x12 pan head screw (E) and M5 gear
washer.
3. Secure the electrical cords (F) with a wire clip
(G) and M5x12 pan head screw (H).
Cord Clamp
Referring to Figure 7:
On the right side of the saw above the motor,
secure the electrical cord (A) that connects the
switch box to the motor with the cord clamp (B) and
M5x12 pan head screw (C).
10
Figure 5
Figure 6
Figure 7
Hide quick links:
Advertisement
Table of Contents
