Operating Controls; Jointer To Planer Setup; Planer To Jointer Setup - Jet JJP-12 Operating Instructions And Parts Manual

Operating Controls

Disconnect
power source before making any adjustments.
Failure to comply may cause serious injury.
Cutterhead
dangerously sharp. Use extreme caution when
working around them. Failure to comply may
cause serious injury.

Jointer to Planer Setup

To change the machine configuration jointer to
planer (refer to Figure 2):
1. Release both cabinet table locks (A) by rotat-
ing the handles toward the operator, then
pulling away from the machine.
2. Raise the table (C) using the handle (B).
Table is heavy. Use care when
raising. Failure to comply may
cause serious injury.
When raised, the table should be in the vertical
position as shown in C, Fig. 3. The latch
(E, Fig. 3) should be engaged, preventing the
table from an accidental forward fall.
3. Position the dust chute (D,H Fig. 3) to the right.
Use extreme care to avoid contact with
cutterhead knives.
Note: The planer table may need to be
lowered to allow clearance needed to position
the dust chute.

Planer to Jointer Setup

Referring to Figure 3:
To change the machine configuration from planer
to jointer:
1. Pull the release knob (F) and reposition the
dust chute (D, G) to the left. It should be
positioned as shown in D, Fig. 2.
Table is heavy. Use care when
lowering. Failure to comply
may cause serious injury.
2. Release the latch (E) and bring the table
forward using the tilt handle (B). It should be
positioned as shown in C, Fig. 2.
3. Lock the table (C) by pushing the lock
handles (A) in toward the machine and rotating
down (away from the operator).
machine from
knives are
9
Figure 2
Figure 3