Secure The Whirlpool To The Subfloor - Kohler K-1394 Installation Manual

Spread a 2" (51 mm) layer of
mortar cement.
3. Secure the Whirlpool to the Subfloor
NOTICE: Do not lift the whirlpool by the piping or pumps, or use the piping or pumps for structural
support of the whirlpool.
Choose the installation option that best applies to your particular installation. Follow the
appropriate instructions.
If the subfloor is not level, shim the whirlpool support blocks as necessary.
Option for Using a Cement or Mortar Bed
NOTE: Do not use gypsum cement or drywall compound for this application, as they will not provide an
acceptable, durable bond.
Spread a 2" (51 mm) thick layer of cement or mortar on the subfloor where the whirlpool will be
set. This will help secure, level, and support the unit. Clear all the material away from the pump
control locations.
NOTE: The pump controls (when the pump banding straps are cut) must rest directly on the subfloor.
With help, carefully lift the whirlpool into place, and make sure the pump controls do not rest in
the bed material.
Insert the drain tailpiece into the trap. Make sure the whirlpool is level and resting on all support
blocks.
Option for Using Construction Adhesive
Apply a generous amount of high-quality construction adhesive to the bottom of the support blocks.
With help, carefully lift the whirlpool into position.
Insert the drain tailpiece into the trap. Make sure the whirlpool is level and resting on all support
blocks.
1022205-2-D
Apply construction
adhesive to the support
blocks.
6 Kohler Co.