Technical Data - Electrolux EUF2047AOW User Manual

10 www.electrolux.com
Problem
The compressor does not
start immediately after
pressing the FastFreeze
or after changing the tem‐
perature.
Water flows on the floor.
Temperature cannot be
set.
The temperature in the
appliance is too low/too
high.
Door does not open easi‐
ly.
If the advice does not lead to
the desired result, contact
the nearest Authorised
Service Centre.

8. TECHNICAL DATA

8.1 Technical data
Height
Width
Depth
Voltage
Possible cause
This is normal, no error
has occurred.
The melting water outlet
is not connected to the
evaporative tray above
the compressor.
The FastFreeze or Shop‐
pingMode function is
switched on.
The temperature regulator
is not set correctly.
The food products tem‐
perature is too high.
The FastFreeze function
is switched on.
You attempted to re-open
the door immediately after
closing.
1550 mm
595 mm
668 mm
230 - 240 V
Solution
The compressor starts after
some time.
Attach the melting water out‐
let to the evaporative tray.
Switch off FastFreeze or
ShoppingMode manually, or
wait until the function resets
automatically to set the tem‐
perature. Refer to "Fast‐
Freeze or ShoppingMode
function".
Set a higher/lower tempera‐
ture.
Let the food products tem‐
perature decrease to room
temperature before storage.
Refer to "FastFreeze func‐
tion".
Wait a few seconds between
closing and re-opening of the
door.
Frequency
Rising time
The technical information is situated in
the rating plate, on the external or
internal side of the appliance and on the
energy label.
50 Hz
11 h