VTech i 5867 Manual page 7

Setup
Connecting Power to Base Unit
Plug the AC power adapter into an electrical outlet, and the DC connector into the
bottom of the Base Unit.
To AC Outlet
Installation and Charge of Battery Cells in Handset
The original Handset that is shipped with your i 5867 system will be
automatically registered to the Base. This Handset is HANDSET 1.
1. Remove the battery cover and place the
new battery cells in the Handset with the
positive and negative poles aligned in the
battery compartment.
2. Replace the battery cover by sliding it
upwards.
3. If the new battery cells are not already
charged, place the Handset in its Charger
or Base Unit, and allow it to charge for at
least 12 hours. After initial charge, a
maintenance charge of 8 hours should
be sufficient.
7