Nikon KeyMission 360 Quick Start Manual page 158

Using the Base Adapter and Base Mount
Attaching the base adapter to the camera allows you to use special accessories such
as a base mount.
• To increase the adhesive strength, attach the base mount for 24 hours or longer
before using the camera.
1
Align the camera screw with the
tripod socket of the camera ( 1 ), and
tighten the screw knob (
2 ).
2
Attach the buckle of the base adapter
to the base mount.
• While holding the two protrusions of the buckle
at the same time, slide the buckle until it clicks
into place.
• When removing the buckle, hold the two
protrusions at the same time, and slide them in the
direction opposite of that for attachment.
3
Adjust the camera angle.
• Loosen the plate lock ( 1 ), set the camera angle
( 2 ),
and then tighten the lock (
3 ).
4
Make sure that there are no foreign substances on the surface to
which the base mount will be attached.
• If there are foreign substances such as dust or water, remove them.
5
Peel off the release liner from the back of the base mount, and
firmly press the base mount so that the entire surface is attached.
7