Husky H30MECH6BLK Use And Care Manual page 8

5
Attaching the Screw driver holder
□
Position the Screw driver holder (I) over the holes on
the right side of cabinet (A). Attach 3 pcs Bolts (CC)
and tighten with supplied Hex Key (DD).
Do not over tighten the bolts.
CAUTION:
6
Power outlet orientation
□
The power outlet can be installed facing either the inside or the outside of the Cabinet.
□
To change the direction of the power outlet, remove the 8 pcs M4x12 bolts from the outlet panel cover, then remove the 8
pcs M4x12 bolts from the blank cover plate on the opposite side. Figure 6:1
□
Gently remove the power outlet and holder and install on the opposite side.
□
Attach the outlet panel cover securing the power outlet in place, and then attach the blank plate on the
opposite side. Figure 6:2
Do not over tighten the bolts.
CAUTION:
Figure 6:1
Figure 6:2
8
A
I
CC