Assembly - Husky H30MECH6BLK Use And Care Manual

Assembly

Two people are recommended for assembly.
CAUTION:
1
Attaching the cabinet handle
□
Position the cabinet handle (B) over the holes on the
cabinet (A).
□
Attach with the bolts (CC) and tighten with supplied
hex key (DD).
The holes in the cabinet are tapped and do not
NOTE:
require nuts.
3
Attaching the Power tool holder
CAUTION:
□
Attach both brackets (E) to the Power tool holder (F) using 4 pcs Bolts (CC) and tighten with supplied Hex Key (DD). Figure 3:1.
□
Position the Power tool holder (F) over the holes on the cabinet (A). Attach with 6 pcs Bolts (CC) and tighten with
supplied Hex Key (DD). Figure 3:2.
□
Attach both hooks (G) to the Power tool holder (F) using 4 pcs Bolts (CC) and tighten with supplied Hex Key (DD). Figure 3:3.
F
E
CC
Figure 3:1
B
CC
A
Do not over tighten the bolts.
E
F
CC
2
Attaching the casters
□ Be sure the drawers and top lid are locked and lay the
cabinet (A) on its back. Use packaging material to
protect the finish.
□ Attach the swivel casters (D) to the unit, on the same side
as the handle (B), insert bolts (AA) through washers (BB)
and swivel caster (D) into the cabinet (A).
□ Tighten all casters with supplied hex key (DD) or 12 mm
wrench/socket.
□ Repeat this process for the fixed casters (C) on the
opposite side of the cabinet (A).
□ Return the cabinet (A) to its upright position.
C
BB
AA
CC
Figure 3:2
6
Do not over tighten the bolts.
CAUTION:
F
G
Figure 3:3
A