Table of Contents
Advertisement
GENERAL: F2
This chapter lists all possible parameters for each menu, and
all possible choices for each parameter. Depending on the
emulation selected, and the key mode (ASCII or ScanCode),
Setup will only present the valid set of parameters and choices
in each menu.
Emulation: Select the "personality" of the terminal. See the Quick menu earlier
in this chapter.
Enhanced: Choose whether the terminal can respond to commands beyond
the limitations of the current emulation. See the Quick menu earlier in this
chapter.
Auto Wrap: [On, Off]
Select whether the cursor drops to the next line when it reaches the right
margin or continues to display characters at the right margin. In ANSI
emulations, the default is off.
Auto Font Load: [On, Off]
Select whether the four font banks (0-3) should automatically be loaded
when screen size or the emulation is changed.
Auto Page: [On, Off]
When the cursor is moved off the page using a command that includes scroll
and Auto Page mode is on, the screen displays the new page. These pages
are numbered from 0 to a maximum of 9. When on, Auto Page will track the
page even if Auto Scroll is off. The up-arrow key does not have a scroll
command embedded, so it cannot be used to view the previous page even
when Auto Page is on.
Auto Scroll: [On, Off]
Choose whether the terminal updates the display when the cursor is moved
beyond the boundaries of the currently viewed screen.
Monitor Mode: [On, Off]
Choose whether control codes will be displayed as their graphic
representations or be acted upon as terminal/cursor commands.
Screen Saver: [Off, 2 min, 5 min, 15 min, 30 min]
Select whether the screen will go blank after lack of activity from the
keyboard or the host of the selected period of time. The first key typed at the
keyboard when the screen is blank will reactivate the display. The keycode
will not be transmitted to the host. The Caps Lock LED will flash while
Screen Saver is active.
32
Advertisement
Table of Contents
