CITROEN BERLINGO Handbook page 74

Ease of use and comfort
Positioning the protective
cover
The protective cover must be installed
whenever the backrest of the outer seat
is folded down and the partition hatch is open.
In row 1, no passengers must be allowed
to sit in the outer seat if the backrest of
the outer seat located behind them in row 2 is
72
lowered and the hatch is open with a long
load.
In row 2, no passengers must be allowed to
sit in the central seat if the backrest of the
outer seat is lowered and the hatch is open
with a long load.
When loading long objects, take care to
install the protective cover correctly.
► Fold the backrest of the outer passenger
seat(s) (depending on the position of the
www.carobook.com
partition).
For more information on the Rear bench seat,
and especially on folding the backrests, refer to
the corresponding section.
For more information on the Two-seat front
bench seat, and especially the retracted position
of the outer seat, refer to the corresponding
section.
► Install the protective cover by fastening its
4 snap hooks to the 4 anchor points on the
partition.
► Pull out the head restraint rods from
the folded backrest(s) of the outer seat(s)
(depending on the position of the partition),
leaving 2 notches visible.
► Load the desired objects.
Avoid placing heavy loads on the
folded-down backrest of row 1.
Whenever possible, place heavy loads on the
floor.
The maximum load permitted on each of the
folded backrests of row 2 is 80 kg.
It is normal for surplus protective cover to
be visible when the partition is positioned
behind row 1.
► Tidy this surplus protective cover in the
space under the glove box.