CITROEN BERLINGO Handbook page 71

Removing the flap
► While holding the flap with one hand, turn the
control at the top of the flap with the other hand
to release it.
► Lower the flap to remove it from its housing.
► Stow it behind the driver's seat, turning the
control at the top of the flap to secure it.
Refitting the flap
► Tilt the flap, with the yellow hinges pointing
downwards.
► Insert the hinges into their housing then press
down fully (to avoid vibrations).
► With one hand lift the flap to close it, then
with the other hand turn the control at the top of
the flap to secure it.
Positioning the protective
cover
Whenever the backrest of the outer seat
is folded down and the partition flap is
open, the protective cover must be installed.
www.carobook.com
No passengers must be allowed to sit in
the central seat if the backrest of the
right-hand outer seat is lowered and the
partition flap is open.
When loading long objects, take care to
install the protective cover correctly.
Read the following procedure carefully.
Ease of use and comfort
► Fold down the outer passenger seat backrest.
► Install the protective cover by fastening its
4 snap hooks to the 4 anchor points on the
partition.
► Pull out the head restraint rods from the
folded backrest, leaving two notches visible.
► Load the desired objects.
The maximum load permitted on the
folded backrest is 100 kg.
► Place the strap of the cover around the head
restraint.
3
69