Mounting Options; Suggested Installation Sequence - Honeywell PRO-2200 Installation Manual

PRO-2200 Output Module PRO22OUT
protection circuit as close to the load as possible (within 12 inches [30cm]). The
effectiveness of the circuit decreases as the distance from the load increases.
Relays 13 through 16 are general purpose relay outputs and are not available when the
board is rack mounted.
N C
1
C
2
N O
3
Use large gauge wires sufficient for the load current to avoid voltage loss.

Mounting Options

This board can be mounted on-edge in the rack-mount enclosure provided by Engineering
Systems or mounted flat against any surface using standoffs under the mounting holes
provided in each of the four corners of this board.
When rack-mounted, four general-purpose output connectors and two dedicated inputs are
not accessible and should not be used.
When mounted flat against surface, the board can be installed remotely and located near
the door(s) being monitored. Use the two dedicated inputs to monitor cabinet tamper and
power faults. The four additional general-purpose outputs allow for the control of local
horns or other equipment.

Suggested Installation Sequence

1. Set Jumpers and DIP-switches.
2. Mount the board in the appropriate enclosure – If mounted in a rack, the
component side of the board should be to the right when facing the rack.
3. Connect the communications and power supply to the circuit boards with the Power
Supply Harness.
WARNING: Do not connect the power supply to the AC Socket until ALL wiring has
4. Connect wiring to alarm input sensors or install jumper wire.
5. Connect relay output wiring.
6. Connect communications wiring to the Intelligent Controller.
7. Recheck wiring for correct connections and continuity.
8. When all boards have been installed, connect the Power Supply Cord for proper
connections and power.
9. Setup the panel controls using the host software.
S -4
LO A D
been installed and rechecked.
Installation Guide
P ow e r S ou rce
13