Table of Contents
Advertisement
Note
TV Guide
may also be used to set timer event.
●
Watching > TV Guide > Timer Programming
Timer Programming
●
Timer Programming
●
received via the signal from the broadcaster or service provider.
For recording using
●
Standby. For reminders to be displayed, the TV must be on.
Depending on the progress of recording, analogue channel may not be
●
selected.
Recording an encrypted (copy-protected) programme may not be possible.
●
2 minutes before the start time, a reminder message may appear if you
●
are watching TV.
– To remove the message and start the programming, press OK.
– To cancel the programming, press EXIT.
LED will turn to orange in Standby mode if
●
Reminder messages will remain displayed until one of the following
●
occurs:
– You press
OK
– The timer event that the reminder is set for ends.
"!" identifies that three or more timer events are overlapped.
●
Rec.
is given priority over Reminder. As for the overlapped recording
events, the first event starts and finishes as programmed. The next event
can then start.
The recording of
●
channel to the programmed channel a few seconds before the start time.
The recording of
●
in
REW LIVE TV
cancelled.
Recording > Recording current programme > REW LIVE TV
For more information of the USB HDD
●
Recording > Technical information
can store up to 15 events.
only works reliably if correct time information is
Timer
Programming, the TV must be either on or in
to view the programme or
Timer Programming
Timer Programming
recording. In this case,
- 94 -
Timer Programming
EXIT
to cancel the reminder.
may automatically change the
will be performed even if the TV is
REW LIVE TV
recording will be
is set.
USB HDD
Advertisement
Table of Contents
