Installation; Warning Symbol; Mains Connection - Williams MHC10 Operating Manual

INSTALLATION

INSTALLATION
REMOVAL OF REDUNDANT APPLIANCES
Heated cabinet appliances contain gases in their
insulation and must be disposed of professionally by
a licensed waste management contractor.
Please ensure that old or redundant appliances are
disposed of safely and legally. It is recommended
that doors are removed prior to disposal in order to
ensure safety.
UNPACKING
Remove all external and interior packing and
accessories. Ensure all such material is disposed
of safely.
Check that no damage has occurred to the
appliance, power cable and plug top during transit. If
damage has occurred do not use the appliance.
The appliance should be installed in a well ventilated
room on a flat and level floor.
PROTECTIVE COATING
The polished stainless steel surfaces are protected
during manufacturing and transport by an adhesive
plastic coating.
This should be removed prior to placing your
appliance into use. Carefully peel away to reveal
the polished stainless steel surface. Care should be
taken to ensure that no adhesive residue remains
on the surface. Any stubborn or tough adhesive
marks can be removed by following the advice on
Page 5.
LEVELLING (CASTORS/FEET)
The appliance should stand level to ensure the
correct operation of self-closing doors.
Models fitted with castors are non-adjustable.
Therefore a level platform / floor should be
provided where the appliance is to be located.
Where swivel and brake castors are fitted and it
has been positioned, please ensure its brakes have
been activated by pressing the metal bar down.
Remember to release the brakes before trying to
move it.
2

WARNING SYMBOL

This symbol is positioned on the
cabinet as a warning that the
item maybe hot and should be
touched with care.

MAINS CONNECTION

Commercial kitchens and foodservice areas
are environments where electrical appliances
may be located close to liquids, or operate
in and around damp conditions or where
restricted movement for installation and
service is evident.
Great care must be exercised at all times when
installing, operating, or servicing this appliance.
For appliances fitted with a moulded plug for safety,
ensure that the mains power cable is extended
free from the refrigeration system to avoid
entanglement. If a plug or mains cable requires
replacement, contact the Williams Spares Office on
+44(0)1553 817017.
The installation of a fixed appliance and periodic
inspection should only be undertaken by a qualified,
skilled, and competent electrician; and connected
to the correct power supply suitable for the load as
stipulated by the appliance data label.
The electrical installation and connections should
meet the necessary requirements to the local
electrical wiring regulations and any electrical safety
guidelines.
All appliances rely upon a suitable connection to
earth to ensure safe operation. If in doubt, contact
a qualified, skilled, and competent electrician before
using the appliance.
We recommend:-
• Supplementary electrical protection with the
use of a residual current device (RCD)
• Fixed wiring appliances incorporate a locally
situated switch disconnector to connect to,
which is easily accessible for switching
off and safe isolation purposes. The switch
disconnector must meet the specification
requirements of IEC 60947