Suzuki NEXA BALENO Owner's Manual & Service Booklet page 344

INSPECTION AND MAINTENANCE
Tightening (viewed from filter top)
(5) ) (5)
(5) Oil filter
(6) 3/4 turn
NOTICE
To tighten the oil filter properly, it is
important to accurately identify the
position at which the filter gasket
first contacts the mounting surface.
9-9
6) Tighten the filter as specified below
from the point of contact with the
mounting surface (or to the specified
( (6) (6)
torque) using an oil filter wrench.
Tightening torque for oil filter:
3/4 turn or
14 Nm (1.4 kg-m, 10.3 lb-ft)
To prevent oil leakage, check that the
oil filter is tight, but do not over-
tighten it.
55T090190
NOTICE
Refilling with Oil and Oil Leakage
Check
1) Pour oil through the filler hole and
install the filler cap.
For the approximate capacity of the oil,
refer to "Recommended fuel / lubricants
and capacities (approx.)" in "SPECIFI-
CATIONS" section.
2) Start the engine and carefully check the
oil filter and the drain plug for leakage.
Run the engine at various speeds for at
least 5 minutes.
3) Stop the engine and wait about 5 min-
utes. Check the oil level again and add
oil if necessary. Check for leakage
again.
NOTICE
• When replacing the oil filter, it is
recommended that you use a genu-
ine MARUTI SUZUKI replacement
filter. If you use an aftermarket fil-
ter, check that it is of equivalent
quality and follow the manufac-
turer's instructions.
• Oil leakage from the periphery of
the oil filter or drain plug indicate
incorrect installation or
damage. If you find any leakage or
are not sure that the filter has been
properly tightened, have the vehi-
cle inspected by a Maruti Suzuki
authorised workshop.
gasket