Suzuki NEXA BALENO Owner's Manual & Service Booklet page 130

BEFORE DRIVING
When the operative wipers suddenly
stop
When the wipers are under heavy load
such as covered by snow and the tem-
perature of the wiper motor becomes high,
the breaker will be activated and the wip-
ers will temporarily stop to protect the
wiper motor from overheating.
If this happens, perform the following oper-
ations:
1) Stop the vehicle in a safe place, and
turn the ignition switch to "ACC" or
"LOCK" position or press the engine
switch to change the ignition mode to
ACC or LOCK (OFF).
2) Move the wiper lever and switch to
"OFF" position.
3) Remove obstacles such as snow on the
wipers.
4) After a while, when the temperature of
the wiper motor becomes low enough,
the breaker will be reset automatically
and you can use the wipers.
If you cannot use the wipers after a while,
there may be another problem. Ask Maruti
Suzuki authorised workshop to have the
wipers inspected.
3-29
Windshield Wipers
(1)
MIST MIST
OFF OFF
INT INT
LO LO
HI HI
You can operate the windshield wipers by
moving the lever (1) upward or downward.
Temporary operation only
MIST
while the lever is up
OFF Off
INT Intermittent operation
LO Low speed operation
HI High speed operation
Windshield Washer
55T030240
If you pull the lever (1) toward you, the
windshield washer fluid will be sprayed
and the windshield wipers will automati-
cally operate a few times.
• To prevent windshield icing in cold
weather, turn on the defroster to
heat the windshield before and
during windshield washer use.
• Do not use radiator antifreeze in
the windshield washer reservoir. It
can severely impair visibility when
sprayed on the windshield, and can
also damage your vehicle's paint.
(1)
55T030250
WARNING