Sony HT-A3000 Operating Instructions Manual page 51

C:\HT2021\SD0\Data\CEK_CEL_E12\5034490111\5034490111HTA3000CEKCELE12\01GB-HT-
010COV.book Page 51 Sunday, August 22, 2021 1:43 PM
HTA3000CELCEKE12\140TBS.fm
 Wait a while, and then try again. If you
unplug the speaker system, it will take
a while before operations can be
made. Wait for 15 seconds or longer,
and then try again.
 Make sure the TV connected to the
speaker system support the Control
for HDMI function.
 The type and number of devices that
can be controlled by the Control for
HDMI function are restricted by the
HDMI CEC standard as follows:
– Recording devices (Blu-ray Disc
recorder, DVD recorder, etc.): up to 3
devices
– Playback devices (Blu-ray Disc
player, DVD player, etc.): up to 3
devices (this speaker system uses
one of them)
– Tuner-related devices: up to 4
devices
– Audio system (receiver/
headphones): up to 1 device (used
by this speaker system)
[PRTCT] flashes in the front panel
display for 5 seconds and the
speaker system is turned off.
 Disconnect the AC power cord (mains
lead) and make sure nothing is
obstructing the ventilation holes of
the speaker system.
[PRTCT], [PUSH], speaker name
([SUB], [RL], or [RR]), and [POWER]
flash alternately in the front panel
display.
 Press  (power) on the corresponding
speaker ([SUB]: optional subwoofer,
[RL]: optional left rear speaker, [RR]:
optional right rear speaker) to turn
each off. For the optional rear
speaker, disconnect the AC power
cord (mains lead), then restart the
speaker system. For the optional
subwoofer, disconnect the AC power
cord (mains lead) and make sure
nothing is obstructing the ventilation
holes of the optional subwoofer, then
restart the speaker system. If they are
reconnected properly, the display in
the front panel display returns to the
normal display.
[HIGH], [TEMP], and [ERROR] appear
alternately for 2 seconds each in the
front panel display, [STANDBY]
appears in the front panel display,
then the speaker system is turned
off.
 High-temperature is detected in the
speaker system. Press  (power) to
restart the speaker system.
[BT TX] appears in the front panel
display.
 Set
[Setup] - [Advanced Settings]
- [Bluetooth Settings] - [Bluetooth
Mode] to [Receiver]. [BT TX] appears
in the front panel display if [Bluetooth
Mode] is set to [Transmitter].
Sensors of the TV do not work
properly.
 The bar speaker may block some
sensors (such as the brightness
sensor), the remote control receiver of
your TV or the emitter for 3D glasses
(infrared transmission) of a 3D TV that
supports the infrared 3D glass system,
or wireless communication. Move the
bar speaker away from the TV within a
range that allow those parts to
operate properly. For the locations of
the sensors and remote control
receiver, refer to the operating
instructions of the TV.
Wireless functions (wireless LAN,
the BLUETOOTH function, or
optional subwoofer/rear speakers)
are unstable.
 Do not place metal objects other than
a TV around the speaker system.
Music that you are not familiar with
suddenly plays.
 The pre-installed sample music may
have been played. Press
select) on the bar speaker to stop
playback.
masterpage: Right
(input
51
GB
HT-A3000
5-034-490-11(1)