Display - JVC HR-XVC16BUC Instructions Manual

DISPLAY

DISPLAY
TV Aspect
Display Mode
Progressive Scan
TV Aspect
DVD
4:3 : Select when a standard 4:3 TV is connected.
16:9 : Select when a 16:9 wide TV is connected.
Display Mode DVD
Display Mode setting works only when the TV Aspect
mode is set to "4:3".
Letterbox: Displays a wide picture with bands on the
upper and lower portions of the screen.
Panscan: Automatically displays the wide picture on
the entire screen and cuts off the portions that do not
fit.
Progressive Scan
DVD
Progressive Scan Video provides the highest quality
pictures with less flickering.
If you are using the Component Video jacks for
connection to a TV or monitor that is compatible with
a progressive scan signal, set Progressive Scan to
On.
To turn on progressive scan:
Connect component/progressive out of this unit to the
input of your monitor/television, set your television or
monitor to component/progressive Input.
1. Select "Progressive Scan" on the DISPLAY menu
then press B.
2. Select "On" using the v / V buttons.
3. Press ENTER / OK to confirm your selection.
The confirm menu will appear.
4 : 3
Letterbox
Off
Move Select
4. When the confirm menu appears on your screen
"Cancel" is highlighted as default. Use the b
button to highlight "Enter".
5. Pressing ENTER / OK will set this unit to
progressive scan mode.
Notes:
• If you set Progressive Scan to ON in error, you must
reset the DVD+VCR. Press STOP (
more than five seconds before releasing it. The video
output will be restored to the standard setting, and a
picture will once again be visible on a conventional
analog TV or monitor.
• Do not turn off this DVD+VCR while the
"PROGRESSIVE SCAN MODE" message is displayed
in the TV screen.
x
) and hold it for
17