JVC HR-XVC16BUC Instructions Manual page 13

Connecting to an amplifier equipped with two
channel digital stereo (PCM) or to an Audio/Video
receiver equipped with a multi-channel decoder
(Dolby Digital™, MPEG 2, or DTS)
1. Connect the DVD+VCR's DIGITAL AUDIO OUT
jacks (COAXIAL X) to the corresponding in jack
on your amplifier. Use a digital (COAXIAL X)
audio cable.
2. You will need to activate the DVD+VCR's digital
output. (See "AUDIO" on page 18).
Digital Multi-channel sound
A digital multi-channel connection provides the best
sound quality. For this you need a multi-channel
Audio/Video receiver that supports one or more of the
audio formats supported by your DVD+VCR (MPEG
2, Dolby Digital and DTS). Check the receiver manual
and the logos on the front of the receiver.
Caution:
This DVD+VCR is not equipped with DTS decoder,
but DTS will be output through Digital coaxial out
when DTS audio stream is selected in DVD disc
soundtrack menu.
Notes:
• If the audio format of the digital output does not match
the capabilities of your receiver, the receiver will pro-
duce a strong, distorted sound or no sound at all.
• Six Channel Digital Surround Sound via digital connec-
tion can only be obtained if your receiver is equipped
with a Digital Multi-channel decoder.
• To see the audio format of the current DVD in the
on-screen display, press A.MONITOR.
Rear of DVD+VCR
A1 A2
R
L
AUDIO INPUT
Amplifier (Receiver)
Connecting External Audio/Video (A/V)
source to DVD+VCR
Connect the VCR IN LINE 1 or LINE 2 jacks on the
DVD+VCR to the audio/video out jacks on your
accessory component, using the optional audio/video
cables. (Refer to page 24 for "Recording from
External Components".)
X
COAXIAL
DIGITAL INPUT
Jack panel of external source
13