JVC KD-G501EE Instructions Manual page 94

Removing the unit
Before removing the unit, release the rear section.
1
B
When using the optional stay
Fire wall
H
Dashboard
ELECTRICAL CONNECTIONS
To prevent short circuits, we recommend that you disconnect the battery's negative terminal and
make all electrical connections before installing the unit.
• Be sure to ground this unit to the car's chassis again after installation.
Notes:
• Replace the fuse with one of the specified rating. If the fuse blows frequently, consult your JVC
IN-CAR ENTERTAINMENT dealer.
• It is recommended to connect to the speakers with maximum power of more than 50 W (both at
the rear and at the front, with an impedance of 4 Ω to 8 Ω). If the maximum power is less than
50 W, change "AMP GAIN" setting to prevent the speakers from being damaged (see page 24 of
the INSTRUCTIONS).
• To prevent short-circuit, cover the terminals of the UNUSED leads with insulating tape.
• The heat sink becomes very hot after use. Be careful not to touch it when removing this unit.
Heat sink
PRECAUTIONS on power supply and speaker connections:
• DO NOT connect the speaker leads of the power cord to the car battery; otherwise, the
unit will be seriously damaged.
• BEFORE connecting the speaker leads of the power cord to the speakers, check the speaker
wiring in your car.
+ +
L
-
-
+ +
R
-
-
2
D
Stay (option)
F
G
Screw (option)
C
Install the unit at an angle of less
than 30˚.
3
Insert the two handles, then pull them as illustrated so that the
unit can be removed.
When installing the unit without using the sleeve
In a Toyota for example, first remove the car radio and install the unit in its place.
Flat type screws (M5 x 8 mm)*
*
Bracket*
*
Pocket
Note : When installing the unit on the mounting bracket, make sure to use the 8 mm-long screws. If longer
screws are used, they could damage the unit.
•
•
•
•
•
•
•
+ +
L
-
-
+
+
R
-
-
2
J
* Not included with this unit.
*
Flat type screws (M5 x 8 mm)*
Bracket*
*
Ω
+
L
-
+
R
-
*
Ω
+
-
+
-