Table of Contents
Advertisement
Camera ID
The ID can be set up to 65,536 (0000 to FFFF). As this
will be memorized in the nonvolatile memory inside,
data will be saved regardless of whether it has been
backed up.
Effect
It consists of the following functions.
• Neg. Art: Negative/Positive Reversal
• Black White: Monochrome Image
Others
Mirror image
The video output from the camera can be reversed left
and right using this function.
Freeze
This function captures an image in the field memory of
the camera so that this image can be output
continuously.
Because communication inside the camera is based on V
cycle, the captured image is always the one 3V to 4Vs after
the sending of a Command. Thus, you can not specify a time
period after sending EVEN, ODD or a Command.
The Image Stabilizer Function
When the Image Stabilizer Function is ON, it helps in
obtaining a stable image free of vibration caused by
jarring movements. For a vibration frequency of
around 10 Hz, correction is approximately 90%.
Note
Be advised that, when using systems equipped with Pan and Tilt
functions, quick starts and stops are corrected for, causing a
different movement from that of the normal image.
Memory (Position preset)
Using the position preset function, 6 sets of camera
shooting conditions can be stored and recalled.
This function allows you to achieve the desired status
instantly, even without adjusting the following items
each time.
• Zoom Position
• Digital Zoom On/Off
• Focus Auto/Manual
• Focus Position
• AE Mode
• Shutter control parameters
• Bright Control
• Iris control parameters
• Gain control parameters
• Exposure Compensation On/Off
• Exposure Level
• Backlight Compensation On/Off
• Slow Shutter Auto/Manual
• White Balance Mode
• R/B Gain
• Aperture
• ICR Shoot On/Off
Custom Preset
As with position preset function, the camera shooting
conditions can be stored. The settings are recalled
when the power is turned on. For setting items, refer to
"Initial Values, Custom Preset and Backup"
Privacy Zone Settings
For subjects requiring special treatment for reasons
involving privacy, designated areas of the image can
be masked.
In this situation, an area can be masked using Privacy
Zone settings. As shown in the diagram below, 12
blocks vertically and 16 horizontally, in a maximum of
6 places, can be masked.
• An example of a Command setting
Using 1 Command for a set: 81 01 04 76 00 02 01 05
02 0D 07 03 05 FF
0
1
2
3
4
5
0
1
A
2
3
4
5
6
7
8
9
A
B
Basic Functions
6
7
8
9
A
B
C
D
E
F
B
10
Advertisement
Table of Contents
