Specifications - JL Audio Slash 250/1 User Manual

APPENDIX D: TROUBLE SHOOTING (CONT.)
"MY AMPLIFIER'S OUTPUT FLUCTUATES WHEN I TAP ON IT OR HIT A BUMP"
Check the connections to the amplifier. Make sure that the insulation
Check the RCA connectors to ensure that both the center pin and
"HOW DO I PROPERLY SET THE INPUT SENSITIVITY ON MY AMPLIFIER"
Please refer to Appendix B (page 13) to set the input sensitivity for
INSTALLATION NOTES:
Use this diagram to document your amplifier's switch and control positions.
18
for all wires has been stripped back far enough to allow a
good contact area inside the amplifier terminal.
the outer shield are making good contact with the input jacks
on the amplifier.
maximum, unclipped output.
JL AUDIO 250/1
APPENDIX E:

250/1 Specifications

GENERAL SPECIFICATIONS:
Recommended Fuse Value: 30A
Recommended Fuse Type: AGU or MaxiFuse™
INPUT SECTION:
Input Type: Differential-balanced with RCA jack inputs
Input Range: Switchable from 200mV - 2V RMS to
800mV - 8V RMS
AMPLIFIER SECTION:
Amplifier Topology: H-Bridge, Class D Mono
with impedance optimization and patented
discrete drive circuitry
Power Supply: Pulse width modulation-regulated
switching power supply
Rated Power: 250W RMS x 1 @ 1.5 - 4Ω (11 - 14.5V)
THD at Rated Power: <0.05% @ 4Ω, 50 Hz
Signal to Noise Ratio: >95 dB referred to rated power
(A-weighted, 20 Hz - 20 kHz noise bandwidth)
Frequency Response: 5 - 300 Hz (+0, -1 dB) /
5 - 500 Hz (+0, -3 dB)
Damping Factor: >500 @ 4Ω/50 Hz, >250 @ 2Ω/50 Hz
JL AUDIO 250/1
CROSSOVER SECTION:
Amplifier Low-Pass Filter: State-variable, 12 dB/octave
Butterworth or 24 dB/octave Linkwitz-Riley with
continuously variable cutoff frequency selection
from 40 - 200 Hz, defeatable
PREAMP OUTPUT:
2-Channel, selectable as full-range (pass-through) or
low-pass or high-pass filtered (tracks with the amplifier
low-pass filter cutoff frequency)
BASS CONTROL SECTION:
Bass EQ: Single-band, fixed frequency/"Q" centered at 48 Hz
with boost adjustment from 0 dB to +15 dB, defeatable
Infrasonic Filter: 24 dB/octave Butterworth high-pass filter
with 30 Hz cutoff frequency, defeatable
DIMENSIONS: (LxWxH):
10.25" x 9.25" x 2.36" (260mm x 235mm x 60mm)
Due to ongoing product development, all specifications are
subject to change without notice.
19