Operation - Husqvarna R112C5 Operator's Manual

Introduction
WARNING: Before you operate the product,
you must read and understand the safety
chapter.
To fill fuel
WARNING: Gasoline is very flammable. Be
careful and refuel outdoors (see
on page 9 ).
CAUTION: Incorrect type of fuel can result in
engine damage.
The engine runs on gasoline with a minimum octane
rating of 91 RON (87 AKI), not mixed with oil. We
recommend biodegradable alkylate gasoline. Do not use
gasoline that contains more than 10% ethanol.
• Do a check of the fuel level before each use and
refuel if necessary.
• Do not fully fill the fuel tank. Keep a space of a
minimum 2.5 cm.
To adjust the seat
• The seat can be tilted forward.
• To adjust the seat forward and rearward, loosen the
bolts below the seat. Move the seat to the required
position and tighten the bolts.
To engage and disengage the drive
system, R112C, R115C
To move the product with the engine off, the drive
system must be disengaged.
516 - 001 - 26.01.2018

Operation

• Pull out the drive system lever fully to disengage the
drive on the axle.
Fuel safety
• Push the drive system lever in fully to engage the
drive on the axle.
Note: Do not use middle positions.
To lift and lower the cutting deck
• To lift the cutting deck to transport position, pull the
lift lever rearward. If the engine is on, the blades stop
to rotate.
13