Dismantling of the Control Board
1) Loosen 9 screws " C" at the back pancle as shown in fi gure 6
Dismantling of the Power Board
1) Loosen 4 screws "D" at the top of the Power Board as shown in
fi gure 7
3 - 2
Figure 6
Figure 7
Dismantling of the DVD Module
1) Loosen 4 screws "E" to remove the DVD Module as shown in
fi gure 8
Service Position
Note:In some service positions the components or copper patterns of one board may risk touching its neighbouring pc boards or
metallic parts. To prevent such short-circuit use a piece of hard paper or other insulating material between them.
3 - 2
Figure 8