Iqinvision IQeye Sentinel Series IQ802 Installation And Operating Instructions Manual page 13

3. Remove the lens cap with the supplied Allen wrench to expose the lens
and IQfocus analog video port.
4. Set the iris on the lens to the 'Open' position, then lock it down with the
iris set screw.
5. The Sentinel camera/housing module can be focused using a field service
monitor. If no analog monitor is available, then focus must be performed by
using a browser to view the camera images.
6. Use the varifocal adjustment on the lens to set the field-of-view, then lock
the varifocal adjustment set screw.
7. Focus the lens using the focus adjustment on the lens, then lock the focus
adjustment set screw.
NOTE: IQinVision provides a desiccant pack for placement inside the lens
cover assembly. IQinVision recommends that you utilize this desiccant
pack to prevent fogging of the inside of the lens glass due to any moisture
that is present when you install the camera.
8. Position the supplied desiccant pack above the lens and wrap it around
the lens between the lens and the lens cover ring. NOTE: DO NOT TUCK DES-
ICCANT PACK INTO OUTER CHAMBER OF LENS COVER. Desiccant pack must
be placed next to the lens within the inner chamber of the lens cover.
9. Clean all glass surfaces, including the surface of the lens, and the inside
and outside of the lens cover using a lens polishing cloth and approved
lens/glass cleaning solution.
10. Carefully replace the lens cover, ensuring that no portion of the desiccant
pack obscures the lens or protrudes beyond the inner lens chamber.
11. When the lens adjustments are complete, reinstall the lens cover and
tighten the two (2) screws with the supplied Allen wrench. It is not necessary
to apply significant force to the tightening of the lens cover screws. Once they
are snug, turn an extra 1/2 turn beyond snug.
13