Video Input - Interphase Color Twinscope Operation Manual

Use the NAV or UP/DOWN
sector size and then use the NAV left/right
adjust the resulting sector direction. Press the softkey
button below the EXIT symbol to save the setting and exit,
or press the button below the CLEAR symbol to disable
(reset) the BEAM adjustment and exit.
A good example of the use of the beam adjustment is when
cruising in deep water where the desired scanning area is
close to the surface (looking for obstructions, etc). In this
situation you could reduce the size of the scanning sector
and then steer it up to the surface. This would result in the
desired coverage but with a much faster scanning speed.
See diagram at bottom of previous page.
Video Inputs
The Color Twinscope has a 3-pin video input connector on
the rear panel. You can connect video cameras, VCR, DVD
and other sources of NTSC OR PAL signals to this
connector and view them in a full-screen format on the
Color Twinscope's display. If more than one camera or
video input is required, you can use a video switch to choose
between several video signals.
Pressing softkey button below the VIDEO selection will
switch the video signal to the display. When the VIDEO
selection is ON, pressing any of the 5 softkey buttons will
turn it OFF and the display will return to the sonar mode.
buttons to adjust the beam
buttons to
29
FORWARD LOOKING SONAR
Use NAV buttons to steer beam sector
Interphase View Cam
Color CCD camera.
Water-resistant. Complete
with 30' cable.
(P/N # 84-6100-000)
Interphase FishCam
Color CCD camera.
Waterproof face. Designed
to fit in thru-hull fitting.
Complete with 30' cable
(P/N # 84-6000-000)
Thur-Hull Housing Kit
(P/N # 84-6200-000)
Blanking Plug for above
(P/N #17-0061-000)
CURSR PWR
VERT HORIZ
DATA
DOWN
RANGE GAIN