Installing The Rs-232 Adapter; Creating A Bluetooth Connection; Creating A Bluetooth Connection With Hyperterminal - Intermec SF51 Instructions Manual

To use the Bluetooth adapter
1 Install the Bluetooth adapter on your host PC.
2 Create a Bluetooth connection between your scanner and host
PC.
3 Collect data with your scanner.
4 (Optional) Configure your Bluetooth communications
parameters.
These instructions describe how to perform each step.

Installing the RS-232 Adapter

1 Insert the RS-232 adapter into an unused serial COM port on
your host PC. Make sure to note the COM port number.
Note: If you are running Keyport Lite, the serial
COM port on your host PC must match the COM
port selected in Keyport Lite.
If the green light inside the adapter starts blinking, your host
PC is providing power to the adapter through Pin 9. You have
successfully installed the adapter.
If the green light inside the adapter is not blinking, you need
to supply power to the adapter. Continue with Step 2.
2 Attach the appropriate country-specific power plug to the
power supply.
3 Connect the power supply to the RS-232 adapter and AC
power. The green light inside the adapter starts blinking.

Creating a Bluetooth Connection

This section describes how to create a Bluetooth connection
with:
• HyperTerminal.
• Keyport Lite.

Creating a Bluetooth Connection With HyperTerminal

1 Start HyperTerminal.
4 RS-232 Bluetooth Adapter Instructions