4 Shorten cable as appropriate, then crimp the fuse holder to
the joined red and black wires (positive). Crimp a terminal
ring to the joined white and green wires (negative). Insulate as
instructed.
5 Make final connections to the forklift power source.
Tools Required
You will need the following tools to properly install the forklift
power supply:
• Common hand tools (screwdriver, pliers, and so on)
• Heat gun for heat shrink tubing
• Wire crimping and stripping tool
• Electric drill, drill bits
• DC Ohmmeter
Preparing the Power Input Cable
Only one of the input connectors will fit the power supply.
To connect the power input cable
1 Attach the corresponding cable connector to the power supply
connector.
2 Slide the connector in as far as possible.
3 Turn the cable connector collar clockwise to secure it.
4 Cut the cable at the unused connector end.
5 Discard the unused connector.
6 Remove the cable connector from the power supply with a
counterclockwise turn of the cable connector collar.
Additional details for installation are covered later in the
section,
"Terminating the Cable" on page
PB50 and PW50 Forklift Power Supply Installation Guide
Chapter 2 — Installing the Forklift Power Supply
16.
11