Omron STC-MBS891U3V Product Specifications And User's Manual page 40

Restriction of ROI operation
・Region 0 is always ON
・Region(X+Y) can be enable (On) after sets ON Region (X) and Region (Y).
(X, Y: Region number, X is any number from 1 to 3, Y is any number from 4, 8 and 12)
・The following restriction exist to set region's Width, Height, OffsetX and OffsetY
Width[RegionN] = Width[Region(N+4)] = Width[Region(N+8)] = Width[Region(N+12)]
Height[RegionN] = Height[Region(N+4)] = Height[Region(N+8)] = Height[Region(N+12)]
OffsetX[RegionN] = OffsetX[Region(N+4)] = OffsetX[Region(N+8)] = OffsetX[Region(N+12)]
OffsetY[RegionN] = OffsetY[Region(N+4)] = OffsetY[Region(N+8)] = OffsetY[Region(N+12)]
(N: Region Number 0to3)
・Overlapped region setting is invalid
・When setting the Horizontal flip, Vertical flip, Horizontal Vertical flip, position of region 0 to 15 are changed.
Please refer to the drawing that follows.
・All of selected data outputs as single image data.
・If Binning / Decimation is enable, obtained Width and Height values are as "Binning/Decimation" ed value.
Region number and position setting on Horizontal Vertical flip.
STC-MBS891U3V / STC-MCS891U3V / STC-MBS123BU3V / STC-MCS123BU3V
Product Specifications and Use's Guide
Region15 Region14
Region11 Region10
Region7 Region6
Width[Region3] Width[Region2]
Region3 Region2
OffsetY OffsetY
[Region12]
[Region8]
WidthMax
Region13
Region9
Region5
Width[Region1]
Region1
OffsetY
[Region4]
Region12
OffsetX
[Region3]
Region8
OffsetX
[Region2]
Region4
OffsetX
[Region1]
Width[Region0]
Region0
OffsetX
[Region0]
OffsetY
[Region0]
No.16S121-03
40/64