Installing The Solenoid Valve - JUKI PS-800SB-2850 Instruction Manual

2-3. Installing the solenoid valve

1) Remove the rear cover of the table stand.
2) Detach the metal plate (second from the left) from the manifold.
There is a rubber sheet between the metal plate and the manifold.
 
1
Rear cover of the table stand
Setscrew
1 2
4
3 4
3) Fit the rubber sheet in place and secure solenoid
valve  .
4) Pull out the connectors from the electrical control
box. Insert the cables of solenoid valve  into
the connectors .
Insert the red cable into the connector No. 1.
Insert the black cable into the connector No. 3 .
Put the cables in the duct for wiring. Connect
the connectors to the corresponding ports of the
electrical control box.
– 7 –
metal plate