FOR SAFE USE Before the installation, operation, and inspection for this product, read the “FOR SAFE USE” and the technical manuals carefully. Also read the other technical manuals, “Sewing Machine Head”, “Control Unit” and “Operation Panel” describing some instructions, which are not in this manual, and use the sewing machine properly.
1. Features Upper Thread-Holding Device will improve the quality of the sewing start point. By gripping the upper thread after thread trimming sewing end, to prevent the thread fall out at the sewing start point. 2. Applicable models PLK-G2010R PLK-G2516 PLK-G2516R PLK-G2516-YU PLK-G4030 / G4030R...
4.3 Accessories (Parts list) 部品コード 数量 品 名 Description Parts No. Amt. Req. MG51A0201 ケッソクバンド Cable tie 5. Assembly procedures CAUTION ★ To work in the presence of residual pressure in the pneumatic circuit It is dangerous. Please work after you remove the residual pressure always. The method of removing the residual pressure, and pull up the handle of the pressure regulating filter regulator, can be done by turning counter-clockwise until the pressure gauge shows 0.
Page 7
5.3 How to setup and cable connection (1) Remove the circuit board cover on the back of the sewing machine. (2) Disconnect the cable connector of the wiper connected to CON11 on the circuit board. (3) Connect the connector of Fig.No.202 cable assy to CON11 on the circuit board. (4) Connect the connector of sensor of the air cylinder to CON9 on the circuit board.
Default value After changing the setting Input signal Signal name Thread trimming protection signal Logical setting normal reversed 6. Operation CAUTION Assembly of this device is completed, please check your work once again. Because there is a case to unexpected behavior, please away from the sewing machine when the power is turned on and the air pressure.