Test Mode - Intermec EasyCoder PC41 User Manual

Test Mode

The Test Mode can be used for:
• To print a hardware and software configuration labels
• To print a pitch label
• To enter the Data Line Print Mode
Do not use continuous stock in the Test Mode. The printer
will not be able to detect any gaps and an error will occur.
Use the Test Mode this way:
After having loaded the printer with full width labels, tickets, or tags,
1
switch off the power to the printer.
Press down and hold the Feed key while turning on the printer.
2
The hardware configuration test label prints out and the firmware pro-
gram and version are sent to the host. You are now in Data Line Print
mode.
Send a few characters down from the host. The printer prints out your
3
data with the hexadecimal equivalent directly underneath it.
Hold the Feed key down to momentarily suspend the test. The printer
4
prints a software configuration test label.
If you press the Feed key again, the pitch label prints.
5
To exit Test Mode:
Switch of the printer.
1
Turn the power back on.
2
EasyCoder PC41 User's Guide
Chapter 3 — Operation
29