Clarion DXZ858RMP Owner's Manual page 39

Cellular phone interrupt
setting
If you connect this unit and your cellular phone
with a unit (Optional, TEL-002), you can listen to
your telephone calls on your car speakers.
• The factory default setting is "OFF".
1. Press the [ADJ] button to set to the adjust
mode.
2. Touch [SETTING].
3. Touch on the left of the display to
select "TEL-SWITCH".
ADJ SETTING
TEL-SWITCH
4. Touch on the right of the display.
Each time you touch, the setting changes in
the following order:
OFF ➜ ON ➜ MUTE ➜ OFF...
OFF:
This unit continues normal operation even
when the cellular phone is used.
Note:
• When connecting a hands-free kit, make sure
that the setting is ON to receive the telephone
audio through the system.
ON:
You can listen to your telephone calls from
the speakers connected to this unit.
∗ When listening to your calls on your car
speakers, you can adjust the volume by
turning the [ROTARY] knob.
MUTE:
The sound from this unit is muted during
telephone calls.
5. Press the [ADJ] button to return to the
original mode.
Setting the auto-volume
function
(CALIBRATE/A-VOL SENS)
You can automatically change the volume to
match your car's speed.
• The factory default setting is "LOW".
1. Press the [ADJ] button to set to the adjust
mode.
2. Touch [SETTING].
O F F
RTN
Common Operations
3. Touch on the left of the display to
select "CALIBRATE".
ADJ SETTING
CALIBRATE
4. Accelerate to a speed of 50 km.
5. When you reach 50 km, touch [START].
Calibration is executed.
After 2 seconds or longer, you will hear a
long beep, and "SUCCESSFUL" will appear
on the display.
If you hear a short beep, this indicates that
calibration failed. Repeat the procedure from
step 4.
6. Next, adjust the sensitivity. Touch
[SETTING].
7. Touch on the left of the display to
select "A-VOL SENS".
ADJ SETTING
A-VOL SENS
8. Touch on the right of the display.
Each time you touch, the setting changes in
the following order:
OFF (no change in volume) ➜ LOW (change
in volume: small) ➜ MID-LOW ➜ MID ➜
MID-HIGH ➜ HIGH (change in volume:
large) ...
9. Press the [ADJ] button to return to the
original mode.
Performing a system check
(SYSTEM CHECK)
This function allows you to perform a system
check when an external equipment is connected
to this unit.
1. Press the [ADJ] button to set to the adjust
mode.
2. Touch [SETTING].
3. Touch on the left of the display to
select "SYSTEM CHECK".
ADJ SETTING
SYSTEM CHECK
[ START ]
RTN
L O W
RTN
[ START ]
RTN
39
DXZ858RMP