System Configuration; Set Up For Pc Development - Intermec 6640 Technical Reference

SECTION 1
"
"

System Configuration

These items apply to the standard computer configuration and are needed for
minimum development. However, the computer can be configured to meet specif-
ic needs. Additional RAM can be obtained to bring the total to 128 MB.
"
"
"
"
"
"

Set Up for PC Development

" NOTE:
Keep the computer on charge while performing setup. See Section 2 for BIOS setup options.
The following is a general approach for equipment setup:
1. Connect power to the dock, install the main battery, and insert the comput-
2. As the boot process is started, a beep signal will be emitted. One beep is a
"
"
Some parts of this publication can be useful for your configuration or ap-
plication. If any of these files are needed, a PDF version of this documenta-
tion will be placed in the "\DOCS" folder on the toolkit CD. If not there,
try the BBS Product Forums. How to access the BBS is on page 1-9.
Finally, for development purposes, consider using external devices if these
are available (or practical) for the application to use in the field.
Computer, with a minimum of 64 MB of system RAM for Windows 2000.
Windows Toolkit.
Main batteries: at least one.
Single dock or wall charger.
A diskette drive to update flash software.
A diskette drive or a type of PC Card storage media for transferring files.
er into the dock.
normal boot. Two or more beeps indicate a BIOS error. If there are four
beeps, a CMOS error was detected but a back up copy of CMOS was suc-
cessfully retrieved from flash, no further action is needed.
To correct a CMOS error using an external keyboard:
a. When prompted. press <F2> for the PhoenixBIOS Setup Utility window.
b. Press <F9> to access the Setup Confirmation window. The "Yes" option
should be highlighted, if not, use the # or " keys to select "Yes."
c. Press [Enter] to load the default configuration.
d. Press <F10>, then press [Enter].
Correct a CMOS error using a pen. It will be necessary to use the four
function hotkeys on the display.
a. When prompted, double-click the display with the pen to enter the
PhoenixBIOS Setup Utility.
b. Click the right side of the [F3] hotkey to move cursor to the Exit menu.
c. Click the right side of the [F4] hotkey to move the cursor down to the
Load Setup Defaults option.
d. Click the [F2] hotkey to access the Setup Confirmation. The "Yes" option
should be highlighted, if not, click the [F3] hotkey.
e. Click the [F2] hotkey to load the default configuration. Click the [F2]
hotkey again to select the Exit Saving Changes option, then click [F2]
to exit the PhoenixBIOS Setup Utility.
6640/6650 Windows 2000 Technical Reference
Introduction
1-7