Table of Contents
Advertisement
VictoryLX 3-leg
Step #4: attach frame to table
• Use the M4.8X22 #2 Phillips round head screws to secure the frame to the underside of the worksurface.
— Use four screws for each top support, two screws for each cross support, one screw for each mounting tab, and six screws for the center leg bracket.
• Check that you have used a total of 22 screws to attach the frame to the table.
M4.8x22
#2 Phillips
round head
cross support
top
support
Step #5: attach left and right legs to frame
The left and right legs do not have a glide attached. The leg with the glide is the center leg.
• Remove the cotter pin from each of the three cam locks and save them for future use.
• Position the legs in the frame.
— First lower the protrusions on the motor housing into the notches.
— Then push the protrusions back toward the top supports into the narrower part of the notches.
• Install the cam lock. With the lever arm upward, insert the long end of the cam lock first, as shown.
• After the cam lock is installed, rotate its lever arm toward the leg until the lever is horizontal. This locks
the leg in place.
• Install the cotter pin to secure the cam lock.
• Check to be sure each leg is securely locked in position.
CAUTION: The cam locks must be in the locked position at all times to secure the legs in place.
position leg
center leg
bracket
install cam lock,
long end first
Page 5
mounting tab
cotter pin
cam lock
rotate lever
to lock leg
Assembly
remove
and save
secure with
cotter pin
Advertisement
Table of Contents
