Table of Contents
Advertisement
VictoryLX 3-leg
Step #1: attach top supports to frame
The two top supports are left and right specific. The short end of each top support must be on
the same side of the frame as the longer frame channel at the open end of the frame segment.
• Insert the latches on the top support into the keyhole slots at the end of the frame channels.
• Tap the top support to fully seat it against the frame.
• Repeat to attach the top support on the other frame segment.
top support
frame
channels
Step #2: assemble frame
With the table top facing down on a soft, clean surface, use the center leg bracket to connect the two frame segments.
• Loosen the eight set screws on each of the frame segments.
• Attach the center leg bracket to the left frame segment. The longer section of the cross channel at the open end should be at the top, toward the rear of the table.
— Align the 90°, 120°, or 180° holes on the bracket with the two holes on the ends of each channel, as shown. This example is a 120° table.
— Adjust the channels as necessary to align the holes.
• Secure the bracket to the left frame segment with four M6x15 socket cap screws. Use the 5mm Allen key to tighten the screws.
• Repeat this procedure to attach the right frame segment.
left frame
segment
longer channel
section
loosen all
set screws
5mm Allen
M10x16
tap to firmly
seat top support
align
holes
center leg bracket
key
Page 3
short end
5mm Allen
key
M6x15 socket cap
Assembly
longer channel
repeat for
right frame segment
Advertisement
Table of Contents
