Assembling And Adjustments; General; Assemble The Stand; Fit The Blade - Husqvarna MS360 Operator's Manual

General

Place the saw on a flat, horizontal and stable surface to
prevent the equipment from tipping over, sliding or
walking on the surface.

Assemble the stand

• Screw together the stand and saw frame with 4
screws.
IMPORTANT! Make sure the stand is
!
fastened securely.
Adjust the working height
Adjustable stand
• Loosen the catch on the side of the rear handle on the
stand and pull the stand up to the working height.
• The hand can be set to a number of fixed heights.
Loosen the catch for one of the fixed heights by
pressing the catch on the rear handle while pulling/
lifting the handle.

ASSEMBLING AND ADJUSTMENTS

• On uneven surfaces, the feet on the stand can be
adjusted individually. The stand foot is adjusted either
by pressing on the foot while lifting up the saw with the
rear handle or by loosening the catch on the foot.
Fixed stand
• Position the machine on flat ground. Adjust the frame
legs and use shimming material if needed to level the
machine.
The machine can also be used without frame legs or
placed on a workbench.

Fit the blade

WARNING! Shut down the machine and
!
disconnect the power plug.
• Flip up the splash guard and remove it.
• Loosen the locking knobs. Open the blade guard.
3
3
• Remove the nut. Remove the blade flange.
• Check that the blade, blade flange and blade shaft are
undamaged. Clean the contact surfaces of the blade
and the blade flange.
2
1
–
English 9