Intermatic FL150HPS Installation Instructions

9.92in.
(252mm)
14.6in.
(370mm)
A qualified electrician should complete all required wiring. Model FL150HPS will accept 120, 208, 240 or 277 Volts AC.
Mode FL150HPST will accept 120, 277 or 347 Volts AC. Fixtures must be properly grounded for safety. A mounting suitable
for outdoor use and rated for wet locations is required. Follow all applicable electrical codes and regulations.
Please see below for list of warnings.
WARNING Electric shock hazard
Disconnect power at circuit breaker or fuse box before
installing or servicing light.
WARNING Fire hazard
USE MIN 60°C SUPPLY CONDUCTORS. CONNECT TO
SUPPLY IN EXTERNAL JUNCTION BOX ONLY.
Lamp and housing become very hot during use. Ensure
free air circulation around unit to dissipate heat. Avoid
enclosed locations and locations where flammable debris
(leaves, cut grass, etc.) might collect. Avoid locations
where humans or animals might accidentally touch fixture.
WARNING Explosion hazard
Never operate light without securing the lens door. When
light is operating, the gas in the lamp inner arc tube is at
high pressure. Never operate light if the fixture lens or
outer glass envelope of the lamp is broken or missing.
WARNING Explosion hazard
Wear safety glasses and gloves when handling lamp.High
Pressure Sodium outer envelope is under vacuum and
could implode.
9.92in.
(252mm)
Mounting
Arm Bolt
Locknut
6.93in.
(176mm)
10.5in.
(267mm)
ELECTRICAL REQUIREMENTS
WARNING
6.93in.
(176mm)
14.6in.
(370mm)
Figure 1
HID Flood Light - FL Series
carefully before installing fixture. Retain
Lamp Types:
High Pressure Sodium 150 Watt
High Pressure Sodium 150 Watt with Tri-Tap
MOUNTING & WIRING
1. Screw the threaded mounting arm of the fixture into 1/2" NPS
mounting hole on mounting device. Tighten locknut to secure
fixture. See Figure 1.
2. Using provided twist on or other approved connectors,
connect the fixture wires to the supply wires as follows:
a.
b.
c.
d.
e.
f.
g.
10.5in.
(267mm)

INSTALLATION INSTRUCTIONS

Model: FL150HPS & FL150HPST
FOR OUTDOOR USE ONLY
NOT FOR USE IN HAZARDOUS
ATMOSPHERES
IMPORTANT: Read instruction sheet
instructions for future reference.
Identify supply voltage.
Open lens door and remove reflector.
Select appropriate fixture wire to match incoming voltage.
Model FL150HPS is shipped with 277 V wire ready for
connection. Model FL150HPST is shipped with 347 V
wire ready for connection. If supply voltage is lower,
cap wire marked 277 V (or 347 V for tri-tap model) with
appropriate twist on wire connector and strip fixture wire
marked with matching voltage.
Confirm unused voltage fixture wires are appropriately
capped within fixture body.
Feed the matching voltage fixture wire through the
mounting arm.
Replace and secure reflector in the same orientation as
shown in Figure 2.
Close and secure lens door to prevent damage while
wiring fixture to mounting.
Lens
Door
Screw
Figure 2 (
Install with Lamp vertical)
Reflector
Screw
Lampholder