Intermatic ET700 SERIES Programming Manual

ET700 SERIES EASY-SET BASIC PROGRAMMING
RESET TIME SWITCH:
1. Set rotary dial in the AUTO position.
2. Press the RESET switch for 3-5 seconds to reset the
microprocessor memory and clear all programmed information.
The display should now show day 1 and 10:00 AM.
NOTE: Do not press the RESET switch after programming has begun
or you will loose all of your programmed information.
TO SET PRESENT TIME AND DAY OF WEEK:
1. Place the rotary dial in the SET position.
2. Press the touch pad for the present day of week.
3. Press the hour and minute for the current time of day.
4. Press AM or PM button.
5. Press CLOCK button.
6. To verify that the correct time and day is set, set rotary dial to
the AUTO position and current time and day should be
displayed.
NOTE: If the current time and day are incorrect, repeat steps 2-6.
TO PROGRAM TIMES:
1. Place the rotary dial in the SET position.
2. Press the touch pad button for the first day to be programmed.
3. Press the hour, minute, AM or PM for the first on time.
4. Press the ON button.
5. Press the hour, minute, AM or PM for the first off time.
6. Press the OFF button.
7. Continue to program each day of the week repeating steps 2-6.
8. When finished set the rotary dial to the AUTO position.
NOTE: If you wish to copy a days on and off times to another day
after step 6 make sure the rotary dial in turned to the SET position,
press the touch pad for the day copied to eg. (Monday day 2) press
2, press the ON button, then press the touch pad for the day copied
from eg. (Sunday day 1) press 1, so press 2 ON 1, 3 ON 1, 4 ON 1
etc.