Troubleshooting - ALDI FERREX GSR2800 User Manual

Troubleshooting

Fault
Standby LED 13 not lit
red.
Device does not shred
Shredded material is
discharged in long,
continuous pieces
Possible cause
Power supply
disconnected
4
Safety switch on the
collection container
set to OFF position (down)
Overload protection has
been triggered
Cutting drum 24 is
rotating the wrong way
The material you want to
shred is too soft
Cutting drum 24 is
blocked
Pressure plate 25 is not
adjusted correctly
Troubleshooting
Troubleshooting
Check the power supply,
the socket and the cable
for damage and function.
Have any damage
repaired by a qualified
service technician.
Set the safety switch
17 is
to the ON position (up).
Reset the overload
protection (see section
"Resetting overload
protection").
Switch the device into
forward mode (see
section "Switching on the
device").
Put in wood or shred dried
twigs.
Remove the blockage (see
section "Removing stuck
material").
Adjust the pressure plate
(see section "Adjusting
the pressure plate").
4
29