Before You Connect; Connecting A Compact Disc Player - Insignia IS-HC040918 User Manual

CONNECTING AUXILIARY COMPONENTS

BEFORE YOU CONNECT.....

CONNECTING THE CABLES
- Protect components from power surges.
- Connect all components before plugging power cords into the
wall outlet.
- Always turn off the receiver and/or components before you
connect or disconnect any cables.
- Always make sure the color-coded plugs match the color of
the terminals in which they are inserted.
- The connection cable plugs and jacks are color-coded as
follows:
Speaker Terminals: Red for positive (+) terminals. Black for
negative (-) terminals.
- Some units may be supplied with connection plugs that are
color-coded red and black instead of red and white. In this
case, the black plug takes the place of the white plug.

CONNECTING A COMPACT DISC PLAYER

Using one paired (red/white) stereo cable, connect your new
receiver to your compact disc player as shown to the right.
To play a CD, press CD, put the receiver in CD mode and
press PLAY .
NOTE:
The AUDIO SOURCE connection can be used as input for any stereo
audio signal.
POSITION CABLES CORRECTLY TO AVOID
AUDIO HUM OR INTERFERENCE
- Insert all cable plugs firmly into their jacks.
- Place audio/video cables to the sides of the receiver's back
panel instead of straight down the middle after you connect
the components.
- Try not to coil any power cables and keep them away from
the audio/video cables as much as possible.
- Make sure all antennas and cables are properly grounded.
Refer to the Safety Tips sheet packed with your receiver.
CD
PLAYER
199
AUDIO
RECEIVER
STEREO RECEIVER AMPLIFIER IS-HC040918
11
L
R