Table of Contents
Advertisement
Chapter 1 Basic Adjustment / Setting
This chapter describes the basic functions that can be adjusted and set by pressing the buttons on the front
of the monitor.
1-1. Loading the Monitor Settings
Basic settings are made in advance at the factory.
It is possible to switch to the following preset settings that have been set in advance.
DisplayPort [sRGB]
DisplayPort [BT.2020]
HDMI [BT.2020]
SDI [BT.2020]
"User1" through "User5" You can save the current setting values and display status in the following items.
1.
Press PRESET.
The preset menu is displayed.
2.
Press F1/Left, F2/Right, F3/Down and F4/Up to select the item to load, and then
press ENTER.
The pre-made settings are loaded and the settings are changed.
Note
• The preset menu will disappear after five seconds have elapsed if no operation is performed.
Basic settings for DisplayPort. The input signal is set to DisplayPort when this item is
selected.
Settings cannot be changed.
For information about the main default settings, see
3).
Basic settings for HDMI. The input signal is set to HDMI when this item is selected.
Settings cannot be changed.
For information about the main default settings, see
3).
Basic settings for SDI 1. The input signal is set to SDI 1 when this item is selected.
Settings cannot be changed.
For information about the main default settings, see
3).
These items are not selectable unless they have been saved. For details, see
current settings to "User1" through "User5"" (page
"4-1. Main Default Settings" (page
"4-1. Main Default Settings" (page
"4-1. Main Default Settings" (page
4).
Chapter 1 Basic Adjustment / Setting
"Saving
3
Advertisement
Table of Contents
