Table of Contents
Advertisement
Function
Advanced
Auto Input
Settings
Detection
Input Skip
On-Screen
Logo
SDI1 Input
Equalizer
RS-232C
Monitor Reset
*1 Disabled when "Display Direction" is set to "180°" or "Mirror".
*2 Disabled when dual screen display (PbyP or PinP).
8
Chapter 2 Advanced Adjustments / Settings
Settings
On / Off
*2
*2
DisplayPort - / Skip
HDMI
SDI 1
SDI 2
DVI
On / Off
On / Off
19200 bps / 115200 bps
OK / Cancel
Description
This function automatically recognizes the
connector through which computer signals
are input, and displays images on the screen
accordingly.
• "On"
When the monitor is connected to multiple
computers, if a specific computer enters
power saving mode or no signals are input
to the monitor, the connector is automatically
changed to another one to which signals are
input.
• "Off"
Set to this when manually selecting input
signals. In this case, you can select the input
signal to display using the INPUT.
For details, see
"1-2. Switching Input Signals"
(page
5).
Note
• When this function is set to "On", the monitor
only enters the power saving mode when
signals are not input from any computer.
When "Auto Input Detection" is "On", select the
port to skip signal detection.
Note
• If all of the ports are set to "Skip", the
operation will be the same as when "Auto Input
Detection" is "Off". Detection of input signals is
not performed.
Select whether to display or hide the logo when
the monitor starts.
Emphasizes the input signal of SDI 1.
Note
• Set to "Off" if noise occurs using the SDI short
cable.
Specifies the transmission rate.
Restores all settings to their default values.
Advertisement
Table of Contents
