Windows 98/98SE/ME CD. The device driver "Unknown Device" (the projector) uses drivers supplied by InFocus. When you plug the USB connector on the LP500/LP530 DVI Cable connector to the USB port on your computer, the computer detects new hardware and starts the Add New Hardware Wizard.
Page 2
Make sure Search For the Best Driver is selected, then click Next. Depending on where your Window Drivers are located, you can select CD-ROM or specify a location. Then click Next. Windows searches for a compatible driver. LP500/LP530 USB Driver Installation for Windows 2000...
Page 3
The other Add New Hardware Wizards appear after you click Finish. You follow the same steps as when you added the first driver. Once you complete adding the drivers, you will install the InFocus driver for the LP500/LP530. See the steps below for that procedure.
You need to install the drivers once on each laptop or desktop PC you use with the LP500/LP530. NOTE The illustrations below refer to the LP130. The dialog boxes you see will refer to the LP500 or the LP530. Otherwise they are the same.
Page 5
If you stored the file on a floppy drive, do not select Floppy Disk Drives. Instead, click Specify a Location, then navigate to the floppy drive on your computer. When Windows finds the driver, click Next. LP500/LP530 USB Driver Installation for Windows 2000...
Page 6
You have completed the setup on the current laptop or desktop computer. You now have keyboard "Page Up" and Page Down" capabilities and mouse control through the remote. If you were in the process of upgrading the LP500/LP530 software, you return to the installation program.